Factory source manufacturing Mobility Scooter with LED Light (ES-016) to Thailand Manufacturers
Factory source manufacturing Mobility Scooter with LED Light (ES-016) to Thailand Manufacturers Detail:
|Motor||different speed brushless motor 350W / 500W|
|Battery||48V/60V 12Ah sealed lead-acid battery All battery with electric protection circuit|
|Performance & Main components|
|Max.speed||25km/h（USA&Canada) ; 32km/h(Europe)|
|Product colour||white ,orange|
|Front brake||drum brake|
|Front fork||hydraulic pressure|
|Rear brake||Expanding brake|
|Brake lever||cut-off when braking|
|Throttle||Twist intelligent speed control|
|Unit packaging||Each in a carton Box|
|Qty / Export carton||1 pc /ctn|
|Export carton dimension||160X36X100CM|
|1×20′footer FCL quantity||50pcs|
|1×40′footer FCL quantity||96pcs|
The price above are based on FOB Ningbo(Zhejiang Province,China).
The quotation is valid within 15 days, we reserve the right to modify the prices if needed.
The prices above are for your reference only, it is subject to our final confirmation.
Product detail pictures:
Factory source manufacturing Mobility Scooter with LED Light (ES-016) to Thailand Manufacturers, The product will supply to all over the world, such as: , , ,
FOR MORE INFO READ THIS VIDEO DESCRIPTION
This is an induction motor, single phase, 127 V. Its nominal speed is 1625RPM.
First I run it with its permanent capacitor, closing the circuit on the two different sides of the capacitor, to show that it will be the cause of the rotating direction.
After that, I remove the capacitor and run it but only with one winding connected at a time. Single phase motors have a main winding and an auxiliary winding.
The black wire of the motor is permanently connected to the phase.
The white wire is the main winding.
The yellow wire is the auxiliary winding.
You will see the starting problem that all single phase motors have in common.
There is no torque on them to start rotating!!!
In this case I crank it with my hand to start it.
It also shows that by cranking it you can give the motor the rotating direction you decide with the crank, and that you can use either the main winding or auxiliary winding to run it but not both at the same time (without the capacitor).
Since the auxiliary and main windings have different inductance and resistance values, the rotor runs faster on one than in the other, but you can start it with your hand in any direction regardless of the working winding.
Any remarks or corrections are well accepted.
Homemade DIY Electric bike / Scooter with Solar Panels in funny video Squamish, BC Canada.
Summer 2011 Version 2.0
Lighter, Faster, Safer +GPS-WiFi-3G
. . . . . & even more Solar Power !
THEKPV began in 2008 by me Terry Hope. I had worked as an engineer aboard Copper Sky. An 88ft steel haul sailboat. The captain would not allow a full size electric scooter.. I had only one option.. design a homemade vehicle that will fit inside a suitcase.
As seen on:
396 Wh A123 Battery
13 km Range
15 min recharge 80%
28 Wh A123 12v booster
50 lbs with Solar Panels Array
50 Watts solar power
12V Kinetic gen device
Homemade electric bike DIY video
Joe, Nick+Cindy, Robert, Sue, Carla
HighlinePC – Polycarbonate
Flatfreetires – tires
A123systems – prismatic batteries
Maxwell Technologies Inc – ultra capacitors
Everbright Solar – photovoltaics, solar cell system
No pedals and not quite a motorcycle, it is a electric scooter or a electronic pocket bike. On sunny days I can charge using sunshine.
By from -
By from -